Control program for Graphtec cutting plotters
Robocut is a simple graphical program to allow you to cut graphics with a
Graphtec Craft Robo 2 Vinyl Cutter model CC220-20 and Sihouette SD. It can
read SVG files produced by Inkscape, but it should also work with other
Robocut is a simple graphical program to allow you to cut graphics with a Graphtec Craft Robo 2 Vinyl Cutter model
CC220-20 and Sihouette SD.
It can read SVG files produced by Inkscape, but it should also work with other SVG files.
Unlike the official programs, Robocut can run on Linux and probably Mac OS X with a tiny bit of work.
It may work with the newer CC330-20 model if the
ROBOCUT(1) User Commands ROBOCUT(1)
Robocut - is used with cutting plotters.
The `Robocut' program plots or cuts SVG files on a Craft Robo
or Silhouette SD or most likely any other customer grade
Graphtec cutting plotter.
robocut [OPTIONS...] [File]
--help Show s
robocut (1.0.8-1) unstable; urgency=low
* Add two more example registration mark files
* Add USB ID 111C as another default
* add debian/README.source
* removed $SOURCES/usr/share/qt4/mkspecs files
-- Markus Schulz <email@example.com> Sat, 06 Aug 2011 03:33:00 -0500
robocut (1.0.6-1) unstable; urgency=low
* Initial release. (Closes: #605345)
-- Markus Schulz <schulz@alphare
* changes in Robocut.pro for qmake so no QT files are shipped (Debian requirement)
This work was packaged for Debian by:
Markus Schulz <firstname.lastname@example.org> on Sat, 26 Nov 20
Browse inside robocut_1.0.8-1_i386.deb
Results 1 - 1 of 1Search over 15 billion files
© 1997-2016 FileWatcher.com