Maintenance Operations Protocol loader daemon
This daemon services load requests on one or all Ethernet interfaces using
the DEC Maintenance Operations Protocol. Normally, a filename (uppercase
and ending in .SYS) is included in the load request; this is looked for in
/tftpboot/mop by default and may be used as a netboot image.
As of 1:2.5.3-1 this is a new source build so please treat carefully!
I have taken the 2.5.3 sources and all the patches from
then manually applied the (some hand-editted) patches to try to
incorporate the 2.5.3->2.5.4 code changes, then added David Kimdon's
patches on top of that.
The code works for me (naturally), it boots
MOPCHK(1) BSD General Commands Manual MOPCHK(1)
mopchk — MOP Check Utility
mopchk [-a] [-v] [filename]
mopchk shows information about which devices are known, version
of mopd suite or information about a MOP-image.
If filename is given, information about the MOP-image is read
from the header of the file.
MOPPROBE(1) BSD General Commands Manual MOPPROBE(1)
mopprobe — MOP Probe Utility
mopprobe -a [-3 | -4]
[-3 | -4] interface
mopprobe prints the ethernet address and nodename of MOP SID
message on the Ethernet connected to interface or all known
interfaces if ‘-a’ is given.
-a Listen on all the Ethe
MOPTRACE(1) BSD General Commands Manual MOPTRACE(1)
moptrace — MOP Tra
MOPD(8) BSD System Manager's Manual MOPD(8)
mopd — MOP Loader
mopd (1:2.5.3-20) unstable; urgency=low
* Add po-debconf translations for Danish
This package is based on the debianization by David Whedon <firstname.lastname@example.org>
with some tweaks by
Browse inside mopd_2.5.3-20_i386.deb
Results 1 - 1 of 1Search over 15 billion files
© 1997-2017 FileWatcher.com